there was a response to my request in the forum..
and hw & sw basics done..
with the links to
i have created a new repository for my
with this example on hand i will use a adafruit PyBadge as main controller – and use the
EZ-Make-Oven as inspiration how to design the software… (all the parts i have on hand are a little bit different….)
As temperature sensor i use the Adafruit MAX31855 Thermocouple breakout board
parts have arrived and i have build the hw:
and over the holidays i also have done the firmware:
and just *along the way* written a CircuitPython library for nonblocking user input…
with this setup i can experiment with the PID…